Eye Lab Factory Is not the next iPhone? I obtained some parts such as cable or flex back plate seems to be.
"Last post . got the part of the blueprint seems to be the next iPhone at some sites until now size Nearly match Comparing the parts that you obtained this figure and design published by the " It seems that it is part of the same parts of the back plate has been posted.
Photograph of the exterior of the housing so can be found at each site, Eye Lab factory tried to verify the internal point of view has been working on this for many years to repair the iPhone.
You think the three screw holes for fixing the image on the right and the foundation.
What concerns me is, (on the opposite side are six), but would seem to be used for locking the screw holes in the mid-frame, iPhone iPhone4/4S like the next four on the right side of the image on the left of the arrow I like not in the shape can be opened from the rear, the glass portion is crimped, such as a tape is predicted only when such exchange is to become flow peeled off the glass part, that removing the mid-frame to then? The guess.
Is also something to be fixed here like there is a four screw holes on the left side to the difference between the top sleep button hole further until now.
Flex sensors, also Home button flex are also smaller portion of the flex cable switch govern sleep, silent mode, the volume also cables
will probably vary quite different because the whole configuration of the contacts until now.
Home button flex cable
Power flex cable
Flex sensor cable
Has become a classy finish plated finish is also here in the mark in the button on the Home button.
Now, let's take a combination of touch panel and glass of Louis and it was available to get this part.
You think (iPhone5?) And the atmosphere or to be roughly like this the next iPhone.
Surface finish to the frame of upscale shaving of aluminum.
Lighter, thinner, iPhone next higher texture.
I'm very excited about the launch of it soon!